Assembly & Set-Up; Contents Of Carton; Handle - Troy-Bilt Storm 3090XP Operator's Manaul

Assembly & Set-Up

Contents of Carton

• One Snow Thrower
• One Snow Thrower Operator's
Manual
• One Chute Assembly
Assembly

Handle

1. Place the shift lever in the Forward-6 position.
2. Observe the lower rear area of the snow thrower to be sure
both cables are aligned with roller guides before pivoting
the handle upward. See Figure 3-1.
Figure 3-1
• Two Replacement Auger Shear Pins
• One Product Registration Card
• One Engine Manual
NOTE: Make certain the cables are seated properly in the
roller guides. See Figure 3-2.
3. Secure the handle by tightening the plastic knob located
on both the left and right sides of the handle. Remove
and discard any rubber bands, if present. They are for
packaging purposes only.
• One Electric Start Cord
• One Chute Control Rod
Figure 3-2
3
7