Table of Contents
Advertisement
RFSDV22/32/42 Freestanding Direct Vent Fireplace
1/2" Gas Supply
1/2" x 3/8" Reducer
3/8" Nipple
3/8" x 3/8" Shut Off
Valve
Fig. 3 Typical gas line installation.
When using copper or flex connector use only ap-
proved fittings. Always provide a union when using
back iron pipe so that gas line can be easily discon-
nected for burner or fan servicing. (Fig. 3) Refer to gas
specification chart for pressure details and ratings.
The fireplace valve must not be subjected to any test
pressures exceeding 1/2 psi. Isolate or disconnect this
or any other gas appliance control from the gas line
when pressure testing.
Do not use this fireplace if any part of
this fireplace has been under water.
Immediately call a qualified service
technician to inspect the heater and to
replace any part control which has been
under water.
Brass
Thermostat
Plug
Bulb
Gas Inlet
Thermocouple
Inlet
Pilot Tube Entry
Pilot Adjustment
Screw
Minimum Rate Screw
(Nonadjustable)
Fig. 4 On fireplaces equipped with Eurosit 630 gas valves
there are brass plugs in two of the holes. These plugs are
not to be removed. The gas inlet hole has a plastic cap in it.
Remove the plastic cap and connect your gas supply line at
this point.
6
3/8" Nipple
3/8" Union
3/8" Nipple
CFM106
Manifold Gas
Outlet
Brass Plug
Pressure
Regulator
Control Knob
Control Knob
Switch for RN/RP Gas Valve
Install on/off switch assembly on either the rear right or
left side of the Fireplace.
1. Remove the screw at the back of the cabinet top
either on the left or the right side of the fireplace.
2. Position switch assembly onto the back of the
fireplace, then fasten two screws as shown in Figure
6.
3. Attach wiring under the clips on the rear casing (Fig.
6) and install wiring through the rear opening of the
fireplace before connecting to the valve as shown in
Figure 5.
Thermopile
Fig. 5 On/Off switch or millivolt thermostat.
ON/OFF Switch Assembly
HV118
FP1331
Fig. 6 Secure wiring under clips on the rear casing.
Installation of Remote
SIT Valve
Clips
FP382a
FP1218a
Screw
(Through
existing
hole)
Wiring for
Milli-Volt
Gas Valves
10001028
Hide quick links:
Advertisement
Table of Contents
