Installing A Card - Datavideo SE-900 Instruction Manual

Installing a Card

When fitting a card please ensure that power is off and disconnected from the SE-900
Base Unit. When fitting a card please take anti-static precautions. The minimum anti static
precaution would be to ensure that you are touching the SE-900 Base Unit while fitting the
card, ideally wear an anti static wristband, or ensure that you are properly grounded by any other
means. ESD damage to cards is rare but will not be covered by warranty if it occurs, so be careful.
The SE-900 has been designed to allow I/O Cards to be easily added or changed to suit your requirements.
The SE-900 is supplied with blanking plates, which cover the unused slots.
To remove the blanking plates simply unscrew at the top and bottom of each plate and it will reveal the slot.
To fit a card, ensure that you are grounded and remove the card from its anti static bag.
You will see that there are slots at the top and bottom of each card bay.
Ensure that the card is the right way up, and slide it into position using the card number at the top of the
card/slot. Ensure that the card is travelling in the provided card slots as these will guide the card into place.
Slide it all the way in so the external plate is level/flush with the Base Unit case and then secure it in place
using the two thumb screws.
N.B. If a card is fitted into the wrong slot it will not operate.
13