Installing The Switcher Image Import/Export Software To A Windows Computer - Datavideo SE-650 Instruction Manual

3.2

Installing the Switcher Image Import/Export software to a Windows Computer

The SE-650 can be connected to a simple IP network and accessed using Windows-based software. If
you have not already set up the SE-650 with a computer then please follow the instructions in the
previous section.
Please download the latest software from the Datavideo SE-650 web page. See:
The install executable file [.msi] will be called SwitcherImageImEx_vXXXX.msi
The vXXXX represents the latest version number.
Double click this .msi file then follow the on screen install wizard prompts.
Once installed launch the Switcher Image Import/Export software.
The Switcher Image Import/Export software has a built-in IP finder, which is designed for PC with
multiple Ethernet cards or DHCP network environment. Please note IP finder can only find devices
that are on the same network domain as the PC. If you cannot remember your device IP, please press
the RESET button to restore the default network settings. Upon launch of the Switcher Image
Import/Export software, you will be prompted to select one Ethernet Interface Card.
Once selected, click OK to start the scanning process.
Note: Please make sure the selected interface card is on the same network domain as the SE-650
device.
Once the SE-650 device is found, the software will connect with the switcher hardware over the IP set
up described in the previous section. If the connection is successfully established, on the software
user interface as shown in the diagram below, the Connect Status will show "Connected" (will display
Not Connected if disconnected).
19
www.datavideo.com