Denso WAVE BHT-805BWB User Manual page 103

Setting the DHCP
1.
Select "3: DHCP" at the SET TCP/IP menu and then press the
ENT key.
The SET DHCP screen on the right displays.
The highlighted setting will be the current setting.
Press the BS/C key to return to the SET TCP/IP menu.
Press the dot key while holding down the SF key at the SET DHCP menu to
display the NETWORK (DHCP) screen (acquisition check screen for IP
address at DHCP).
Press the BS/C key at the NETWORK (DHCP) screen to return to the SET
DHCP screen.
If the acquired IP configuration is displayed when the IP
- Point -
address, subnet mask or default gateway is set to a value
other than "0.0.0.0", the DHCP does not display on the screen
shown on the right.
"1: TIMEOUT":
Sets the timeout for acquiring the IP configuration from the DHCP
server. The entry range is from 00001 to 32767 seconds.
Up to 32767 seconds can be entered, but in actual operation,
- Point -
a maximum of 190 seconds is available since the number of
retries and retry intervals are determined by the system.
To set the DHCP:
(1) Press the ENT key.
(2) The mode changes to entry mode and the cursor displays, allowing the
setting to be entered with the numerical keys.
To delete a single character, press the BS/C key. To delete the entire entry,
press and hold the BS/C key, or press the SF key and BS/C key simultaneously.
(3) Enter the desired value, and then press the ENT key.
Press the BS/C key to return to the SET FTP menu.
Barcode Handy Terminal
BS/C key / SF key + [.] key
87