Removing The Interface Cable - Motorola Symbol DS3408 Product Reference Manual

Open the clamp and plug the interface cable modular connector into the cable interface port on the bottom of
2.
the digital scanner handle.
Connecting the Interface Cable
Figure 1-3
Gently tug the cable to ensure the connector is properly secured.
3.
Close the clamp, push it back into place and tighten the screws on the clamp to secure the cable into the
4.
bottom of the digital scanner.
Securing the Clamp
Figure 1-4
Connect the other end of the interface cable to the host (see the specific host chapter for information on host
5.
connections).
NOTE Different hosts require different cables. The connectors illustrated in each host chapter are examples only.
The connectors may be different than those illustrated, but the steps to connect the digital scanner are the
same.

Removing the Interface Cable

Loosen the two screws on the cable clamp at the bottom of the digital scanner and gently pull the clamp away
1.
from the bottom of the digital scanner.
Open the clamp and unplug the interface cable modular connector from the cable interface port on the bottom
2.
of the digital scanner handle. Carefully slide out the cable.
Follow the steps for
3.
Installing the Interface Cable on page 1-2
Getting Started
to connect a new cable.
1 - 3