Scanning Sequence Examples; Errors While Scanning; User Preferences Parameter Defaults - Motorola Symbol DS3408 Product Reference Manual

4 - 2 Symbol DS3408 Product Reference Guide

Scanning Sequence Examples

In most cases, scanning one bar code sets the parameter value. For example, to set the beeper tone to high, scan
the High Frequency (beeper tone) bar code listed under
fast warble beep and the LED turns green, signifying a successful parameter entry.
Other parameters, such as Serial Response Time-Out or Data Transmission Formats, require scanning several
bar codes. See these parameter descriptions for this procedure.

Errors While Scanning

Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter.

User Preferences Parameter Defaults

Table 4-1 lists defaults for user preferences parameters. To change the default values, scan the appropriate bar
codes in this guide. These new values replace the standard default values in memory. To recall the default
parameter values, scan
NOTE See
miscellaneous default parameters.
User Preferences Default Table
Table 4-1
Parameter
User Preferences
Set Default Parameter
Parameter Scanning
Beeper Tone
Beeper Volume
Power Mode
Time Delay to Low Power Mode
Trigger Mode
Picklist Mode
Decode Session Timeout
Timeout Between Decodes, Same Symbol 89h
Beep After Good Decode
Fuzzy 1D Processing
Decode Mirror Images
*Set Defaults on page
Appendix A, Standard Default Parameters
Parameter
ECh
91h
8Ch
80h
92h
8Ah
F0h 92h
88h
38h
F1h, 02h
F1h, 19h
Beeper Tone on page
4-3.
for all user preferences, hosts, symbologies, and
Default
Number
Set Defaults
Enable
Medium
High
Continuous On
1 Minute
Auto Aim
Disabled Always
9.9 Sec
0.6 Sec
Enable
Enable
Never
4-5. The digital scanner issues a
Page
Number
4-3
4-4
4-5
4-6
4-6
4-7
4-9
4-10
4-11
4-11
4-12
4-12
4-13