Motorola SYMBOL LS3408 Quick Start Manual

SYMBOL LS/DS3408
Quick Start Guide
http://www.motorola.com/ls3408 See Product Reference Guide
for detailed information
http://www.motorola.com/ds3408
1
RS-232
Scanner Emulation
Scanner not working
No power to scanner Incorrect interface cable used
Check system power; Ensure that correct
ensure power supply, interface cable is used
if required, is connected
Scanner decoding bar code, but data not transmitting to host
Scanner not programmed for correct host interface
Check scanner host parameters or edit options
Set Defaults
SET DEFAULTS
USB Host Types
HID KEYBOARD EMULATION
IBM HAND-HELD USB
RS-232 Host Types
STANDARD RS-232
ICL RS-232
NIXDORF RS-232 MODE A
1
2
CORD ATTACHMENT
2
HOST INTERFACES
NOTE: Cables may vary depending on configuration
USB
TROUBLESHOOTING
Interface/power cables are loose
Check for loose cable
connections
Interface cable is loose
Check for loose cable connections
SYMBOL LS/DS3408 PROGRAMMING BAR CODES
IBM 46XX Host Types
PORT 5B
PORT 9B
Keyboard Wedge Host Types
IBM PC/AT and IBM PC COMPATIBLE
Level
Auto Aim trigger mode is the default (red laser aiming pattern automatically turns on when
the digital scanner senses motion). After 2 seconds of inactivity, the red laser aiming pattern
automatically shuts off. To turn off default, scan Level below to activate the red laser aiming
pattern and decode processing upon trigger pull. Decode processing continues until bar code
decodes, trigger release or Decode Session Timeout is reached.
NIXDORF RS-232 MODE B
FUJITSU RS-232
OPOS/JPOS
3
4
1 Tether Plate
2 LED Indicators
3 Scan Window
4 Scan Trigger
3
Keyboard Wedge
Wand Emulation
Scanner not decoding bar code
Scanner not programmed
for bar code type
Ensure scanner is programmed
to read type of bar code being
scanned
Scanned data incorrectly displayed on host
Scanner not programmed for correct host interface
Check scanner host parameters or edit options
Variants
Laser Scanner Digital Scanner
(ER, FZ) (DS)
Accessories
IntelliStand Forklift Holder
4
IBM 46XX
Bar code unreadable Distance between scanner
and bar code incorrect
Ensure bar code is not defaced;
try scanning test bar code of same
Move scanner closer to
bar code type
or further from bar code
Wand Emulation Host Types
SYMBOL WAND
ENABLE CONVERT TO CODE 39
DISABLE CONVERT TO CODE 39
Level (00h)
Enter Key (Carriage Return/Line Feed)
SCAN OPTIONS
<DATA><SUFFIX>
ENTER