Host Parameters - Motorola Symbol DS3408 Product Reference Manual

7 - 4 Symbol DS3408 Product Reference Guide
RS-232 Host Parameters
Various RS-232 hosts use their own parameter default settings. Selecting standard, ICL, Fujitsu, Wincor-Nixdorf
Mode A, Wincor-Nixdorf Mode B, OPOS/JPOS, Olivetti, or Omron sets the defaults listed in
Terminal Specific RS-232
Table 7-2
Parameter
Transmit Code ID No
Data Transmission Data as is
Format
Suffix CR/LF
(7013)
Baud Rate 9600
Parity None
Hardware None
Handshaking
Software Handshaking None
Serial Response 2 Sec.
Time-out
Stop Bit Select One
ASCII Format 8-Bit
Beep On <BEL> Disable
RTS Line State Low
Prefix None
*In the Nixdorf Mode B, if CTS is low, scanning is disabled. When CTS is high, scanning is enabled.
**If you select Nixdorf Mode B without connecting the digital scanner to the proper host, it may appear
unable to scan. If this happens, scan a different RS-232 host type within 5 seconds of cycling power to the
digital scanner.
Standard
ICL
(Default)
Yes Yes
Data/Suffix Data/Suffix
CR (1013) CR (1013)
9600 9600
Even None
RTS/CTS None
Option 3
None None
9.9 Sec. 2 Sec.
One One
8-Bit 8-Bit
Disable Disable
High Low
None None
Wincor-N
Fujitsu ixdorf
Mode A
OPOS/JPOS
Yes Yes
Data/Suffix Data/Suffix
CR (1013) CR (1013)
9600 9600
Odd Odd
RTS/CTS RTS/CTS
Option 3 Option 3
None None
9.9 Sec. 9.9 Sec.
One One
8-Bit 8-Bit
Disable Disable
Low Low = No
data to send
None None
Table 7-2
Wincor-
Nixdorf
Olivetti
Mode B/
Yes
Prefix/Data/
Suffix
ETX (1002)
9600
Even
None
Ack/Nak
9.9 Sec.
One
7-Bit
Disable
Low
STX (1003)
Omron
Yes
Data/Suffix
CR (1013)
9600
None
None
None
9.9 Sec.
One
8-Bit
Disable
High
None