Grill Assembly - GE Monogram ZDP486ND Technical Service Manual

6. On rangetops, remove the two 1/4-in. hex-head
screws and the Phillips-head screw (on each
side), from the back of the control panel fl ange.
7. Pull the control panel straight out from the
chassis, then carefully lower the control panel
onto a protective, supportive surface.
Rangetop Control Panel in Service Position

Grill Assembly

Note: The following describes the procedure to
remove the grill assembly.
To remove the grill:
1. Lift off the grill grate and grill frame.
2. Lift the grill baffl e straight up and remove it from
the 4 support posts located on the side walls.
(See
Control Features - Rangetop
3. Remove the two 1/4-in. hex-head screws that
attach the igniter to the igniter bracket, then
place the igniter aside.
4. Remove the 2 Phillips-head screws that hold the
refl ector trim in place.
5. Lift up and remove the trim and screen.
– 31 –
.)
(Continued next page)