Meat Probe Receptacle And Harness - GE Monogram ZDP486ND Technical Service Manual

12. Slide the hidden bake element out from the
range.
Main Oven Bake Element
Companion Oven Bake Element
Main Bake
Wire Harness
Main Oven Element Wire Identifi cation
Element Harness Connection to Range Wire
Pin #1 Yellow - Bake1 Element
Pin #2 Red/Yellow - Bake 2 Element
Pin #3 Brown - Bake 2 Element
Pin #4 Brown - Bake1 Element
Companion Oven Element Wire Identifi cation
Element Harness Connection to Range Wire
Pin #1 Brown - Bake 1 and 2 Element
Pin #2 Red - Bake 2 Element
Pin #3 Yellow - Bake 1 Element
Companion
Bake Wire
Harness
– 63 –

Meat Probe Receptacle and Harness

Each oven is equipped with a meat probe receptacle
and harness. The probe outlet is located near the
top right front corner of the oven cavity on 30- and
36-in models, and on the right side of the main oven
and the left side of the companion oven on 48-in
models. The meat probe outlet is connected to the
logic board in the control compartment with the
harness. The meat probe has a resistance value of
30K-50K Ω at room temperature.
To remove the meat probe receptacle:
1. Separate the light housing from the oven liner
on the probe side of the oven cavity. (See
.)
Light Assemblies
2. Remove the 3/8-in. hex-head nut that holds the
meat probe outlet to the inside of the oven.
3. Pull the meat probe receptacle out of the oven
liner.
4. Note the location of each wire, then disconnect
the wires from the meat probe receptacle.
Oven
(Continued next page)