Indicator Light Assembly; Task Light Switch - GE Monogram ZDP486ND Technical Service Manual

Task Light Switch

The task light switch is attached to the left side of
the control panel with a 3/4-in. hex
To replace the task light switch:
1. Place the control panel in the service position.
(See .)
Control Panel
2. Disconnect the task light switch wire harness,
3. Remove the wire ties that attach the switch wire
harness to the LED wire harness,
4. Remove the 3/4-in. hex nut
5. Slip the nut over the harness connector, then
remove the switch from the control panel.
Nut
nut.
from the switch.
– 46 –

Indicator Light Assembly

Each surface unit (surface burner, grill, and griddle),
utilizes an indicator light consisting of a circuit board
with an attached Light Emitting Diode (LED). When
a surface unit knob is turned to the ON position, the
circuit board activates the LED and light is directed to
the indicator lens of that surface unit's bezel.
Each light assembly is attached to a manifold valve
bracket and connected to the valve switch wiring
harness. Each light assembly can be replaced
separately.
To remove the indicator light assembly:
1. Place the control panel in the service position.
(See .)
Control Panel
2. Disconnect the LED wire harness.
3. Remove the Phillips-head screw that attaches
the LED to the valve bracket.
Disconnect
Indicator Light
Assembly
Clip