GE Monogram ZDP486ND Technical Service Manual page 66

Procedure B:
1. Remove the racks, rack support, and light cover.
(See
Oven Light Bulbs
2. Remove the two 1/4-in. hex-head screws that
attach the light housing to the oven liner.
3. Using a small fl at blade screwdriver, pry out the
4 tabs that lock the housing to the oven liner.
4. Separate the light housing from the oven liner.
5. Carefully pull the oven light housing from
the oven liner while guiding the wire harness
through the opening.
6. Disconnect the oven light wire harness.
Note: Upon reassembly, ensure displaced insulation
is returned to it's original position.
Oven Light Bulbs
Caution: Before replacing a bulb, disconnect
electrical power to the oven at the main fuse or
circuit breaker panel.
Each oven is equipped with halogen light columns
located on the side walls of the oven. The lights
come on when the door is opened or when the oven
is in a cooking cycle.
Each light assembly consists of a removable
light cover with two locking clips and a light
compartment with three halogen bulbs.
Be sure to let the light cover and bulb cool
completely. For your safety, do not touch a hot bulb
with bare hands or a damp cloth.
To remove oven light bulb:
1. Remove the racks from the oven. (See
.)
Racks
2. Using a 7/16-in. nutdriver, remove the four nuts
holding the rack supports to the oven wall.
, this section.)
Oven
3. Remove the glass light cover by pulling its
back edge out and rolling it toward you. Do not
remove any screws.
Locking
clips
Note: If the locking clips fell from the glass lens
cover, hold them on the cover, in the correct position,
while replacing the cover on the light compartment.
4. Using gloves or a dry cloth, remove the burned-
out light bulb by pulling it straight out.
To replace:
Use a new 120-volt Halogen
bulb, with G8 pins, not to
exceed 25 watts.
Replacement bulbs may be purchased by calling
800.626.2002. Order Part Number WB25T10064.
Note: The light cover must be in place when using
the oven.
– 66 –