Door Assembly; Oven Components - GE Monogram ZDP486ND Technical Service Manual

Door Assembly

The oven door can be separated into 2 assemblies.
The outer assembly consists of the outer panel and
a replaceable door handle. The inner assembly is
made up of the inner panel, door gasket, 3 glass
panels, insulation, heat barrier, and replaceable door
hinge assemblies.
To separate the door assemblies:
1. Remove the door.
2. Place the door assembly, gasket side up, on a
protective surface.
3. Remove the 4 Phillips-head screws (3 on
companion oven door) that attach the inner
door assembly to the outer door assembly.
4. Remove the 2 Phillips-head screws located
under the door gasket at the top of the door.
Note: The inner door assembly is heavier than the
outer door assembly.
5. Separate the inner door assembly from the
outer door assembly.

Oven Components

To replace the outer door assembly:
1. Separate the door assemblies. (See
the door assemblies, this section
2. Remove the 3/8-in. hex-head screw that
attaches the right-side of the door panel
refl ector to the right-side liner support.
3. Remove the remaining 3/8-in. hex-head screw
that attaches the right side liner support and
support spacer and remove the two 3/8-in.
hex-head screws that attach the left-side liner
support and spacer.
4. Lift and remove the refl ector and liner supports
from the outer panel.
5. Remove the remaining four 3/8-in. hex-head
screws (2 on each side) that attach the door
handle assembly to the outer door panel.
Note: The tubular door handle is inserted and
secured to each handle support with a 1/8-in. Allen
screw located inside the support.
Note: For further details, see Oven Doors (exploded
view), this section.
– 51 –
.)
Door Panel Refl ector
Liner
Support
Support
Spacer
Allen Screw
(Continued next page)
To separate