Log Set Installation; Log Set Assembly - Jøtul GI 350 DV Scan 65i Installation And Operation Instructions Manual

Log Set Assembly

This is the heart of your fireplace. Much time and
effort has been devoted to attaining a lively, real-
istic flame picture while simultaneously achieving
efficient fuel combustion and effective heat output
under a variety of installation conditions. The flame
picture you experience, however, will be affected by
a number of variables peculiar to your installation
such as venting configuration, environmental and
weather conditions, and fuel type. Log placement is
critical to the final flame picture. Pay particular at-
tention to placing the log pieces as illustrated here.
Carefully unpack and arrange the logs as outlined
below. CAUTION: The logs are fragile. Please handle
each piece with care.
Use safety gloves to handle the log parts as the
ceramic fibers can irritate skin.
1. Place the Rear Log in position on the pegs in the
log support at the back of the firebox as shown
in fig. 24.
2. Set the Middle Log in place on the burner plate
pegs as shown in fig. 25.
3. Set the Left Log on the appropriate pegs as
shown in fig. 26.
4. Set the Right Log on the appropriate pegs as
shown in fig. 27.
5. Lightly scatter the Ember Stones, included in
the Log Set package, over the burner plate. Place
them directly on top of the burner base and
around the log parts. DO NOT ALLOW EMBER
STONES TO BLOCK THE PILOT ASSEMBLY AREA.
The burner ports directly in front of the pilot
must remain clear for proper pilot ignition.
6. Replace the Glass Panel Frame using the Latch
Release tool to engage the latches with the
frame. See fig. 1.
Left Log
222448
Figure 23. Log Set Parts.
0
Rear Log
Right Log
222446
222447
Middle
Log
222449
Figure 24 Engage rear log with base pegs.
Figure 25. Place middle log on the two center pegs.
Figure 26. Engage left log on its pegs.
KEEp pILOT AREA
CLEAR
Figure 27. Engage right log on its pegs.