Log Set Installation - Jøtul Direct Vent Gas Fireplace GZ550s Installation And Operation Instructions Manual

Logset Assembly
Unpack and arrange the logs as outlined below.
CAUTION: The logs are fragile. Handle with care.
1. Set the Log Base in position in the bottom of the
firebox, pushing it all the way to the rear.
2. Seat Left Log A in the shallow pocket at the left
side of the Base. Fig. 39.
3. Engage Forked Log B with the pin on Log A and
position as shown in Fig. 40.
4. Position the short, flat side of Log End C within
the shallow pocket at the right side of the Base.
See Fig. 41.
5. Engage Log Tip D with the pin in Log B and
position it against Log C. Fig. 42 shows the
correct placement. There should not be a large
gap between the two pieces as shown in Fig.42a.
6. Position Log E to the rear of Log C. Note that the
cutout at in the lower end should be oriented to
the left to clear the Restrictor lever as shown in
Fig. 43.
7. Replace the Glass Panel Frame: Engage the top
of the frame with the three tabs at the top of
the firebox. Push the bottom of the frame
against the firebox face and pull the Frame
Latches out to engage them with the slots in the
bottom of the frame.
Figure 39. Position Log A in the pocket at left.
Figure 40. Engage Log B with Log A.
20
Log Base
Log B
Figure 41. Position Log C to the right.
Figure 42. Correct Position: Engage Log D to Logs B and C.
Figure 42a. Incorrect Log Position.
Log E
Figure 43. Engage notched Log E.
Log End C
Log Tip D