Log Set Installation - Jøtul GZ 550 DV II Acadia Installation And Operation Instructions Manual

Logset Assembly
Unpack and arrange the five logs as outlined below.
1. 1. 1. 1. 1. Seat Right Log (1) on the pin on the right side of
the Burner Skirt. fig. 41.
2. 2. 2. 2. 2. Set Rear Log (2) on the pins at the rear of the
Burner Skirt. This log should overlap the back of
the Right Log.
3. 3. 3. 3. 3. Set the Left Log (3) on the pins at the left side of
the Burner Skirt.
4 4 4 4 4 . . . . . Set the end of Front Log (4) into the pocket at the
rear of Left Log (3). Engage the other end with the
pin in the middle of the Burner Plate. Fig. 42.
5 5 5 5 5 . . . . . Engage the upper end of the Cross-over Log (5)
with the pin in the Rear Log. Fig. 42. Set the
Cross-over Log across the top of the lower end of
the Front Log (4) as illustrated.
6. 6. 6. 6. 6. Spread a layer of ember stones evenly over the
f i r e - p a r t s . c o m
surface of the Burner Plate. Allow for 1/4" clear-
ance between the stones and the inner edge of
the Burner Skirt.
7 7 7 7 7 . . . . .
the frame with the three tabs at the top of the
firebox. Push the bottom of the frame against
the firebox face and pull the Frame Latches out
to engage them with the slots in the bottom of
the frame.
Figure 41. Install Right Log, Rear Log and Left Log in
that order.
Engage the top of
Figure 42. Install Front and Cross-over logs as shown.
Figure 43. Install ember stones, keeping clearance
around the pilot crossover area.
Jøtul GZ 550 DV II
Pilot
Area
21