Optional Wall Panel Kits - Jøtul GI 350 DV Scan 65i Installation And Operation Instructions Manual

Optional brick panel Kit
Assembly
CAUTION: THESE pANELS ARE ExTREMELY FRAGILE!
SUppORT EACH pIECE WITH bOTH HANDS AND
HANDLE GENTLY.
Install the optional Brick Panel Kits before installing
the log set. No fasteners or tools are required. Brick
panels are shown here, however, Corrugated panels
install in the same way. Both style panels are reversible.
Rear Panel
Left Side
Panel
Figure 20. Align the Rear panel mortar joints with
those in the side panels.
1. Remove the Glass Frame, if you have not already
done so. See fig. 1, pg. 3.
2. Remove the Log Set. These parts are not fastened.
Simply lift them out of the firebox.
3. Install the Rear Panel. Orient the rear panel to
align with the brick courses on the Side Panels as
shown in fig. 20. Place the panel against the back
wall of the firebox, resting on the log shelf as in
fig. 21.
4. Install the Side Panels. Orient the panel straight
upright, with the leading edge on the support
shelf. Slide the panel all the way back, keeping it
sandwiched between the side wall and the end of
the air deflector. See fig. 22.
5. Replace the Log Set, and Glass Assembly.
Figure 21. Install Rear Panel.
Right Side
Panel
Figure 22a. Install Side Panel vertically.
Figure 22b.
Install the Side Panels taking care to clear the Air
Deflector.
Air Deflector
Air Deflector
1