Appendix A: Remote Installation; Remote Control Installation - Jøtul GI 350 DV Scan 65i Installation And Operation Instructions Manual

Appendix A

Remote Control Installation

The optional Jøtul Remote Control 129706 may be in-
stalled in place of the factory-installed manual burner
switch. Follow this procedure:
1. Remove the Burner Switch Box from the valve
compartment. Remove the switch coverplate and
disconnect the wires from the TH and TH/TP termi-
nals under the valve.
2. Remove the Receiver from the plastic Fireplace
Mounting Plate.
a) Pry off the slide switch cap.
b) Press down, then release the battery box to
disengage it from the receiver box.
c) Slide the receiver box out from the plastic
fireplace mounting plate. See fig. 38.
d) Replace the battery box into the receiver.
3. With the battery box oriented to the right, attach
the Receiver assembly onto the front of the in-
sert Burner switch box using the two sheet metal
screws previously removed from the original cover-
plate. See fig. 39.
4. Attach the Receiver Coverplate to the Receiver
using the two small screws supplied in the kit.
Replace the battery box and slide switch cap.
Place the switch in the OFF position.
5. Run the receiver wires out the back of the switch
box and connect the leads to the TH and TH/TP
terminals on the valve. DO NOT DISCONNECT ANY
WIRES FROM THE VALVE.
6. Reinstall the switch box to the valve compartment
floor using the same nut previously removed.

Receiver
Fireplace Mount-
ing Plate
Figure 38. Remove the Receiver from the fireplace
mounting plate.
Receiver
Slide
Switch
Cap
Receiver Cover-
plate
Figure 39. Install Remote Receiver into the
burner switch box.
Switch Box