Yamaha CW50L Service Manual page 78

IC"'S I [ S.EE.,.O.E.O..O...O. C"'S
3. Install: 9. Clamp:
• Steering shaft • Speedometer cable
• Upper bearing race (Top) (D ° Front brake cable
• Bearing race cover (_) (to head pipe with the band)
° Washer NOTE:
• Ring nut Refer to "CABLE ROUTING" in CHAPTER 2.
NOTE:
Hold the steering column until it is secured. 10. Apply:
• Lithium soap base grease
4. Tighten: (to throttle cable end and handlebar right
• Ring nut end).
11. Install:
NOTE: oThrottle grip
Refer to "STEARING HEAD ADJUSTMENT" in • Throttle cable
CHAPTER 3. • Bracket
• Front brake lever assembly
• Handlebar switch (right)
NOTE:
Refer to "CABLE ROUTING" in CHAPTER 2.
7. Install:
_ - r_:, (_ oHandlebar_ 12.Connect:
(_) - Bolt (_) (New) • Rear brake cable
° Nut (_) (New) ° Handlebar switch leads
NOTE: • Brake switch lead
• Fit the handlebar bridge (_) into the steering
column n otcher (_). 13. I nstall:
• Front fender
NOTE:
Refer to "CABLE ROUTING" in CHAPTER 2 for NOTE:
proper cable and lead routing. Refer to "COVERS" in CHAPTER 3.
13. Adjust:
...... • Front brake free play
• Before installing the handlebar, wipe the oil • Rear brake lever free play
off the insertion portion using thinner, etc. • Throttle free play
• Install the bolt (_)from the left as shown.
I< _ _--_ Front Brake Lever Free Play:
Handlebar Bolt O:
60 Nm (6.0 m.kg, 43.4 ft.lb) 10 ~ 20 mm (0.4 ~ 0.8 in)
Rear Brake Free Play:
10 ~ 20 mm (0.4 ~ 0.8 in)
8. Install: Throttle Cable Free Play:
° Band 1.5 ~ 3.0 mm (0.06 ~ 0.12 in)
NOTE:
Refer to "CABLE ROUTING" in CHAPTER 2. NOTE:
Refer to "FRONT BRAKE ADJ USTMENT-REAR
BRAKE ADJUSTMENT-THROTTLE CABLE
ADJUSTMENT" in CHAPTER 3.
6 - 27 6 - 28