Yamaha CW50L Service Manual page 7

IGE" I 1 I°E"
SCOOTER IDENTIFICATION INFO
A
- 8 IMPORTANT INFORMATION
INFO
INFORMATION ALL REPLACEMENT PARTS
1. Use only genuine parts for all replacements.
SCOOTER IDENTIFICATION
Use
oil and/or grease recommended by MBK/
VEHICLE IDENTIFICATION NUMBER _'-.._ _ _O YAMAHAforassemblyandadjustment.Other
The vehicle identification numbere is stamped _._ __ _ brands may be similar in function and appear-
_ _ _ into the frame, ance, but inferior in quality.
NOTE:
The vehicle identification number is used to
identifyyourscooterand maybe usedto register _ _ (_ GASKETS, OIL SEALS, AND O-RINGS
your scooter with the licensing authority in your 1.All gaskets, seals and O-rings should be re-
state, placed when an engine is overhauled. All
gaskets surfaces, oil seal lips and O-rings
I Initial serial number: I must be cleaned.
2.Properly oil all mating parts and bearing dur-
VG54RWN0*WA101301 ing reassembly. Apply grease to the oil seal
lips.
The engine serial number@ is stamped into the PINS
_ crankcase. _ 1.All lock washers/plates (_ and cotter pins
must be replaced when they are removed.
NOTE: _ Lock tab(s) should be bent along the bolt or nut
The first three digits of these numbers are for _MHr,IH' flat(s) after the bolt or nut has been properly
model identifications; the remaining digits are tightened.
the unit production number.
I Initial serial number:
O_ BEARINGS AND OIL SEALS
4UY-200101 1. Install the bearing(s) (_ and oil seal(s) ® with
their manufacturer's marks or numbers facing
NOTE: outward. (In other words, the stamped letters
Designs and specifications are subjectto change must be on the side exposed to view.) When
without notice, installing oil seal(s), apply a light coating of
lightweight lithium base grease to the seal
lip(s). Oil the bearings liberally when installing.
CAUTION: _
Do not use compressed air tospin the
__ bearings dry. This causes damage to the
bearing surfaces.
1 -1 1 -2