Yamaha CW50L Service Manual page 72

IC"ASI IE'111 .E,.W,EE"
whee earn0s Br keshoesO
Refer to the section "FRONT WHEEL IN- • Return spring (_)
SPECTION". NOTE:
4. Check: The arrow mark ® must point outwards.
• Brake lining surface ......
Glazed spots _ Eliminate with sandpaper. CAUTION_
lo When installing the springs and the brake
NOTE: shoes, t akecare nottodamage thesprings
After sanding the brake lining remove dust parti-
c e soeresoewieanco nt
• Wear indicator (_
• Camshaft lever 0
5. Measure:
• Brake lining thickness NOTE:
Out of specification _ Replace • Align the wear indicator tipO with the line "A"
--_ Brake Lining Thickness: I as shown.
4.0 mm (0.16 in) • Align the punch marks C_).
i Wear limit: 11
2.0 mm (0.08 in) I_>1 Camshaft Lever Bolt:
6. Check: 7 Nm (0.7 m.kg, 5.1 ft.lb)
• Brake drum inner surfaca "__
Oil/Scratches _ Repair. _ 4. Install:
• Plain washer C)
7. Measure:
• Brake drum inside diameter @ t • Brake cable
Out of specification _ Replace, /C)
_ Brake Drum Wear limit: I
t10.5 mm (4.35 in)
34S006 _012
ASSEMBLY INSTALLATION
_L___ Reverse the =REMOVAL" procedure. Reverse the REMOVAL procedure.
Notethefollowing points. Note thefollowing points.
1. Install: 1. Clean:
• Brake camshaft O • Rear wheel axle
NOTE:
Apply lithium soap base grease onto the brake
camshaft (_)and pin (_).
\_ 2. Install:
After installing the brake camshaft, remove _ _ • Rear wheel
• Plain washer •
the excess of grease. • Nut
NOTE:.
E Make sure the splines on the wheel hub fit onto
the rear drive axle.
346O13
6-15 6-16