Yamaha CW50L Service Manual page 51

E.O..E.SSE.B..O.O, OST"E"T IE"OI'IO'S I UST"E"T I "O1 '1
8. Instalh 5. Install:
I • Dowel pin • V-belt
I XJ _ • Gasket Place the V-belt around the secondary sheave,
° Secondary sheave assembly(_) and compress the secondary sheave spring
• Clutch housing (D hard so that the V-belt moves toward the clutch
hub.
NOTE:
• The arrow on the V-belt must point to the front.
_0o2_ • Make sure the V-belt is not stained with oil or
grease.
9. Tighten:
• Nut (_) (secondary sheave) I / _3_4(_5(_3 6. Install:
Use sheave holder _ • Shim (_)
I_ • Primary fixed sheave @
c c c Sheave holder: • Washer (_)
PIN. 90890-01701 • One-way clutch (_)
• Washer (_)
I_ I Nut (secondary sheave): I ,Nut (_
40 Nm (4.0 m.kg, 28.9 ft.lb) 31_o_,
PRIMARY SHEAVE 7. Tighten:
_ (_ (_ _{_l_ 1. Clean: Nut O (primary sheave)
• Primary sliding sheave face (D i_>1
• Primary fixed sheave face (_ Nut (primary sheave):
• Collar _) 30 Nm (3.0 m.kg, 21.7 ft.tb)
• Weight (_
• Primary sliding sheave cam surface (_ NOTE:
When tightening the nut (primary sheave), hold
31_4 3190_ the magneto rotor using the flywheel holding tool
®.
2. Install:
• Slider (_)
• Collar (_
3, Check:
oCam operation
31,o_., Unsmooth operation _ Repair.
4. Install: 8. Adjust:
_ 319026 319O28
4-33 4-34