Installation - Yamaha CW50L Service Manual

COVERS
I INSP
_ _ffr_ I B-8 I COVERS I INSP_ _1
t_ _ 8. Remove: ___ 4. Install:
, _ • Footrest board (D • Front panel (D
• Bottom cover (_) • Main switch cover (_)
:__ . _ NOTE:
Insert the main switch cover and turn it clockwise.
_ NOTE:
Insert the projections of the front panel into the
slot of the footrest board.
eove Conn
• Screws (Handlebar cover) (D : ::_' ; • Headlight leads
10. Disconnect :
• Speedometer cable (_) 6. Install:
• Couplers • Front fender 0
11. R emove: NOTE:
o Handlebar cover (Upper) (_) Insert the projection "a" of side cover into the slot
"b" of footrest board.
/ INSTALLATION: f 7. Install:
Reverse the "REMOVAL" procedure. Note • Central coverO
the following points.
1. Connect: NOTE:
o Speedometer cable Insert the projection "a" of central cover into the
• Couplers [l_'_:_"_ _ _ slot "b" of footrest board.
NOTE: _(D
Correct routing of cables and wires is essential
for a safe operation of this scooter. Refer to
2."CABLEInstaIt:ROUTING" in Chapter 2. ___"_ "\_ __ 8. Install:
• Rear carrier (D
• Helmet holder
• Handlebar cover _ • Seat
NOTE: NOTE:
Be careful not to pinch any wires with the covers. After con necting the tail and flasher light lead,
locate the couplers inside the rear fender.
I'1
(Rear carrier):
17 Nm (1.7 m.kg, 12.3 ft.lb)
_ _ _ 3. Install: - Nut (Rear carrier):
• Bottom cover (_) 15.5 Nm (1.55 m.kg, tl.21 ff.lb)
' • Footrest board (_) Nut (Seat):
8 Nm (0.8 rn.kg, 5.8 ft.lb)
NOTE:
Mesh the projections of footrest board and bot- NOTE:
_ tom cover. When installing the covers, be careful not to
_ _ damage the mounting clips.
3-3 3-4