Installer Selectable Features - Clifford Concept 450 Installation Manual

installer selectable features

To enter the Installer Selectable Features grid follow the instructions for the User
Selectable Features with the exception of step 3. Perform step 3 as described below
to enter the Installer Selectable Features grid.
Hold/Chirp/Release - After entering the PIN code, press and hold
chirps once. Continue holding for approximately 10 seconds until the siren chirps
three times, then release the button. You have now entered the feature selection posi-
tion of the Installer Selectable Features grid.
First
Press
Then
Press
Delay domelight
off/arm/disarm/both
Software select*****
proximity/shock
* P1 = Pulsed channel output is disabled with the ignition on or the alarm is
armed.
** P2 = Pulsed channel output works anytime.
*** Only with optional IntelliStart connected.
**** Only with optional SmartWindows connected.
*****Remote adjustable sensor port: The 3-pin proximity/shock port can be
used for either the proximity sensor or the remote adjustable magnetic res-
onance impact sensor. This programming branch is used to choose the sen-
sor software. The proximity sensor is the default 2 chirp setting. The impact
sensor is the 1 chirp setting.
28
Lock pulse Acc. output A P1*/
single/double P2**/timer A/latch/
latch (ignition reset)
Unlock pulse Acc. output B P1*/
single/double P2**/timer B/latch/
latch (ignition reset)
Lock pulse One time valet
duration off/on
0.8/3.5 sec
Timer A duration
off/on for acc output A
Acc. output B
Timer B duration
auto-activate
for acc output B
Not used
until the siren
Program RPM
Engine type
petrol/diesel***
Program
SmartWindows 4****
Horn output
pulsed/latched
Auto immobilization
off/on
Not used
www.directed.com