Power Requirements; Endpoint Connectors - Inter-Tel 8600 User Manual

Power Requirements

The Model 8600 requires either an individual power supply unit or a centralized
power source to power the endpoint. Check with your system administrator about the
specific power requirements for your endpoint.
Before connecting a power supply unit, make sure it is compatible with your end-
point. The following individual power supply units are compatible with the Model
8600:
•
Inter-Tel Power Supply Unit (Part Number 806.1114/806.1117 in Europe)
•
Red Hawk Single Port PowerSense
•
An industry-standard IEEE 802.3 Power Supply Unit
It is recommended that you plug your endpoint's individual power supply unit into an
Uninterruptible Power Supply (UPS). If your endpoint's power supply unit is not
plugged into a UPS and the power fails, the current telephone call will be dropped.
NOTE:
Contact your network administrator to order a new power supply unit for your
endpoint.
Your system may be configured to use a centralized power source (power over Ether-
net) rather than an individual power supply unit. Your system administrator will
explain how to connect your endpoint to the centralized power source. If your end-
point uses power over Ethernet, do not connect an individual power supply unit to the
endpoint.

Endpoint Connectors

The Model 8600 endpoint has a jack located on the back of the endpoint used to con-
nect a handset or headset. In addition to the handset/headset jack, the Model 8600 has
a LAN connector required for an IP endpoint. Two light-emitting diodes (LEDs) on
the LAN/Power jack indicate link status and the speed of the connection.
The Model 8600 endpoint connectors include:
•
Headset/Handset Jack: Connects to a headset or handset.
•
LAN/Power Jack: Connects to a network hub or a switch.
For more information about your endpoint's connectors, power supply, and supported
ethernet devices, contact your network administrator.
®
Inter-Tel Model 8600 User Guide (ITP Mode)
™
(Part Number 901.0407)
5