Debug Sw-Vlan Notification - Cisco Catalyst 2950 Command Reference Manual

debug sw-vlan notification

debug sw-vlan notification
Use the debug sw-vlan notification privileged EXEC command to enable debugging messages that
trace the activation and deactivation of Inter-Link Switch (ISL) VLAN IDs. Use the no form of this
command to disable debugging output.
Syntax Description accfwdchange
allowedvlancfgchange
fwdchange
linkchange
modechange
pruningcfgchange
statechange
Defaults
Debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.1(6)EA2
Usage Guidelines The undebug sw-vlan notification command is the same as the no debug sw-vlan notification
command.
Related Commands Command
show debugging
show vlan
Catalyst 2950 Desktop Switch Command Reference
A-20
debug sw-vlan notification {accfwdchange | allowedvlancfgchange | fwdchange | linkchange |
modechange | pruningcfgchange | statechange}
no debug sw-vlan notification {accfwdchange | allowedvlancfgchange | fwdchange | linkchange
| modechange | pruningcfgchange | statechange}
Enable VLAN manager notification of aggregated access interface
Spanning Tree Protocol (STP) forward changes.
Enable VLAN manager notification of changes to the allowed VLAN
configuration.
Enable VLAN manager notification of STP forwarding changes.
Enable VLAN manager notification of interface link-state changes.
Enable VLAN manager notification of interface mode changes.
Enable VLAN manager notification of changes to the pruning
configuration.
Enable VLAN manager notification of interface state changes.
Modification
This command was first introduced.
Description
Displays information about the types of debugging that are enabled. For
syntax information, refer to Cisco IOS Configuration Fundamentals
Command Reference For IOS Release 12.1 > Cisco IOS System
Management Commands > Troubleshooting Commands.
Displays the parameters for all configured VLANs or one VLAN (if the
VLAN name or ID is specified) in the administrative domain.
Appendix A Debug Commands
78-11381-05