Cmos Reset; Disk-On-Chip Selection; Flash Bios Write Protect - Intel Motherboard Raptor AT Installation Manual

CMOS Reset

This option is provided as a convenience for those who need to reset
the CMOS registers. It should always be set to "Normal" for standard
operation. If the CMOS needs to be reset, turn off the system, move
JP5 to 2-3, turn the system on, move jumper to 1-2 and press reset.
Table 1-1 CMOS Reset
Reset CMOS
JP5
* Manufacturer's Settings.

Disk-on-Chip Selection

The jumper JP7 allows selection for the addresses on Disk-on-Chip
devices.
Table 1-2 Disk-on-Chip Selection
Addresses
D000h/D400h* Closed
D400h/D800h
D800h/DC00h
DC00h/D000h
* Manufacturer's Settings.

Flash BIOS Write Protect

To program the optional flash BIOS (Location U9 – Figure 1-2) use
JP2 to disable write protection. For regular standard BIOS use default
settings.
Table 1-3 Flash BIOS Programming Selection
Flash
Write-protect
JP2
*Manufacturer's Settings.
Chapter 1: Pre-Configuration
Normal
1-2*
JP7 JP7
1-2 3-4
Open
Open Closed
Open Open
Open Open
Enabled
1-2*
Clear CMOS
2-3
JP7 JP7
5-6 7-8
Open Open
Open Open
Closed Open
Open Closed
Disabled
2-3
5