Pci/Plug And Play Setup - Intel Motherboard Raptor AT Installation Manual

Raptor AT – Installation Guide
Device 0 (Primary Master IDE)
Device 1 (Primary Slave IDE)
Device 2 (Secondary Master IDE)
Device 3 (Secondary Slave IDE)
When set to Monitor, this option enables event monitoring on
the device. If set to Monitor and the computer is in a power
saving state, AMIBIOS watches for activity. The computer
enters the Full On state if any activity occurs. AMIBIOS reloads
the Standby and Suspend timeout timers if device activity
occurs. The settings are either Monitor or Ignore.
LAN Wake-Up
The settings for this option are: Disabled (default) and Enabled.

PCI/Plug and Play Setup

PCI/PnP Setup options are displayed by choosing the PCI/PnP
Setup from the AMIBIOS Setup main menu. All PCI/PnP Setup
options are described in this section.
Plug and Play Aware OS
Set this option to Yes if the operating system installed in the
computer is Plug and Play-aware. AMIBIOS only detects and
enables PnP ISA adapter cards that are required for system boot.
The Windows 95 and 98 operating systems detect and enable all
other PnP-aware adapter cards. Windows 95 is PnP-aware. Set
this option to No if the operating system (such as DOS, OS/2,
Windows 3.x) does not use PnP. You must set this option
correctly or PnP-aware adapter cards installed in your
computer will not be configured properly. The setting is
either No or Yes. The Optimal and Fail-Safe default setting is
No.
PCI Latency Timer (PCI Clocks)
This option sets latency of all PCI devices on the PCI bus. The
settings are in units equal to PCI clocks. The settings are 32, 64,
28