Intel Motherboard Raptor AT Installation Manual page 37

Power Saving Type
The settings for this option are: Sleep, Stop Clock and Deep
Sleep. The default setting is Sleep.
Standby / Suspend Timer Unit
This option allows a timer to be set for stand by and suspend
modes. The options are: 32 seconds, 4 miliseconds, 4 minutes
(default) and 4 seconds.
Standby Timeout
This option specifies the length of the period of system
inactivity when the computer is in Full-On mode before the
computer is placed in Standby mode. In Standby mode, some
power use is curtailed. The settings are multiples of the standby
suspend timer unit. The default setting is Disabled.
Suspend Timeout
This option specifies the length of the period of system
inactivity when the computer is already in Standby mode before
the computer is placed in Suspend mode. In Suspend mode,
nearly all power use is curtailed. The settings are multiples of
the standby suspend timer unit. The default setting is Disabled.
Slow Clock Ratio
This option specifies the speed at which the system clock runs in
the Standby Mode power saving state. The settings are
expressed as a percentage between the normal CPU clock speed
and the CPU clock speed when the computer is in the power-
conserving state. The settings are 0-12.5%, 12.5-25%, 25-
37.5%, 37.5-50%, 50-62.5%, 62.5-75% and 75-87.5%. The
Optimal and Fail-Safe default setting is 50-62.5%.
Display Activity
Device 6 (Serial 1)
Device 7 (Serial2)
Device 8 (Parallel)
Device 5 (Floppy)
Chapter 2:BIOS Configuration
27