Intel Motherboard Raptor AT Installation Manual page 39

96, 128, 160, 192, 224 and 248. The Optimal and Fail-Safe
default setting is 64.
PCI VGA Palette Snoop
This option must be set to Enabled if any ISA adapter card
installed in the computer requires VGA palette snooping. The
setting is either Disabled or Enabled. The default setting is
Disabled.
Allocate IRQ to PCI VGA
This option determines if the BIOS should assign an IRQ to the
VGA card. The settings are either Yes or No. The default setting
is No.
PCI IDE Bus Master
Set this option to Enabled to specify that the IDE controller on
the PCI local bus has bus mastering capability. The setting is
either Disabled or Enabled. The default setting is Disabled.
Off-board PCI IDE Card
This option specifies if an off-board PCI IDE controller adapter
card is used in the computer. You must also specify the PCI
expansion slot on the motherboard where the off-board PCI IDE
controller card is installed. If an off-board PCI IDE controller is
used, the onboard IDE controller on the CPU board is
automatically disabled. The settings are Auto (default), Slot1,
Slot2, Slot3, Slot4, Slot5 and Slot6. If Auto is selected,
AMIBIOS automatically determines the correct setting for this
option.
Off-board PCI IDE Primary IRQ
This option specifies the PCI interrupt used by the primary IDE
channel on the off-board PCI IDE controller. The settings are:
Disabled, INTA, INTB, INTC, INTD and Hardwired. The
Optimal and Fail-Safe default setting is Disabled.
Chapter 2:BIOS Configuration
29