Intel Motherboard Raptor AT Installation Manual page 21

Chapter 1: Pre-Configuration
the information supplied with your drive for more information on this
subject.
Connect the floppy cable (not included) to the system board. Then
connect remaining ends of the ribbon cable to the appropriate
peripherals. Connect the Ethernet cable (included). Connect the mouse
(included) and the parallel/2 serial cable (included). Finally, connect
the IDE cable (not included) to the system. Then connect remaining
ends of the ribbon cable to the appropriate peripherals. This concludes
the hardware installation of your Raptor AT system. Now it is a good
time to re-check all of the cable connections to make sure they are
correct.
11