Intel Motherboard Raptor AT Installation Manual page 73

Checkpoint
Code
The keyboard controller interface test completed.
82h Writing the command byte and initializing the circular
buffer next.
The command byte was written and global data
83h initialization has completed. Checking for a locked key
next.
Locked key checking is over. Checking for a memory
84h
size mismatch with CMOS RAM data next.
The memory size check is done. Displaying a soft error
85h and checking for a password or bypassing WINBIOS
Setup next.
The password was checked. Performing any required
86h
programming before WINBIOS Setup next.
The
completed. Uncompressing the WINBIOS Setup code
87h
and executing the AMIBIOS Setup or WINBIOS Setup
utility next.
Returned from WINBIOS Setup and cleared the screen.
88h Performing any necessary programming after WINBIOS
Setup next.
The programming after WINBIOS Setup has completed.
89h
Displaying the power on screen message next.
The first screen message has been displayed. The
<WAIT...> message is displayed. Performing the PS/2
8Bh
mouse check and extended BIOS data area allocation
check next.
8Ch Programming the WINBIOS Setup options next.
The WINBIOS Setup options are programmed.
8Dh
Resetting the hard diskcontroller next.
The hard disk controller has been reset. Configuring the
8Fh
floppy drivecontroller next.
The floppy drive controller has been configured.
91h
Configuring the hard disk drive controller next.
Initializing the bus option ROMs from C800 next. See
95h
Table D-7 for additional information.
Initializing before passing control to the adaptor ROM
96h
at C800.
Initialization before the C800 adaptor ROM gains
97h
control has completed. The adaptor ROM check is next.
Appendix D: Industrial Devices
Description
programming before WINBIOS Setup has
63