Printing A Self-Test; Connecting The Printer; Installing A Data Cable - Datamax LP3 User Manual

Printing a Self-Test

Note: When printing a self-test, use standard 3 inch receipt
media without Q-Marks to show all printed data.
1. Press and hold the power button for approximately three (3)
seconds until printing begins. For information on button
functions, see
2. After printing begins, release the power button.

Connecting the Printer

The LP3 is designed to transmit and receive data from a host
terminal. The host terminal may be your computer, handheld, or
laptop. Communication can occur by using a data cable to
connect the printer and the host terminal.

Installing a Data Cable

1. Before connecting your printer to a host terminal, verify your
printer's settings. For more information, see
Test on page 12
2. Turn off the printer.
3. Insert the data cable's plug into your printer's data port
(Figure 29).
Figure 29
4. Connect the data cable to the host and/or device you are
using.
Using the Control Panel on page 15
.
Data port
12
S U Y
ETTING P
Printing a Self-
P
OUR RINTER
.