Am Frequency Step Setup (Australian Model) - Integra DTR-5.8 Instruction Manual

First Time Setup—Continued
AM Frequency Step Setup
(Australian model)
You must specify the AM frequency step used in your
area. Note that when this setting is changed, all radio
presets are deleted.
1
Press the [Receiver] button, fol-
lowed by the [Setup] button.
The main menu appears onscreen.
2
Use the Up and Down [
buttons to select "7. Hardware
Setup," and then press [Enter].
The Hardware Setup menu appears.
7. Hardware Setup
1. Remote Control
2. Zone2
3. Tuner
4. Analog Multich
5. HDMI
3
Use the Up and Down [
buttons to select "3. Tuner," and
then press [Enter].
The Tuner menu appears.
7–3. Tuner
AM Frequency Step
4
Use the Left and Right [
buttons to select:
10 kHz: Select if 10 kHz steps are
used in your area.
9 kHz: Select if 9 kHz steps are used
in your area.
5 Press the [Setup] button.
The Setup menu closes.
Note:
• This procedure can also be performed on the AV
receiver by using its [Setup] button, arrow buttons, and
[Enter] button.
]/[ ]
]/[ ]
9 kHz
]/[ ]
53