Avaya 3600 Series User Manual page 32

To terminate incoming broadcasts:
Press Terminate and at the confirmation prompt, press Yes. PTT is immediately stopped and the phone exits the
·
PTT session. Only the current call is terminated from the phone, no other phone is affected.
When the next PTT call period starts, the phone is again in the receive state. You can rejoin an active session by
initiating a PTT call.
Note
If you do not wish to receive any further PTT calls, it is advisable to disable the PTT feature in the on-hook menu.
·
A phone call can be answered while in a PTT call session. To announce an incoming call, the phone will ring with a low-
volume ring and a system message is displayed.
To answer an incoming PBX call during a PTT call:
1. Press Start Call. The PTT call session will be pre-empted and no PTT audio will be heard. If you do not press
Start Call to answer the phone call, the PTT display will be shown after the ring has stopped.
2. To go back on-hook when the PBX call is over, press
becomes active again. If an active PTT call has not ended, the PTT audio starts playing again.
To make a PBX call during a PTT call:
To start a call during a PTT session, press
·
described previously.
Receiving an incoming PTT call during a PBX call:
If a PTT session is started during a PBX call, the PTT 'receiving alert' sound will play softly in the speaker audio. You
·
can continue your PBX call normally. To switch to the PTT call by ending the PBX call, press
3600 Phones
IP Office
End Call. The PTT goes out of pre-empted mode and
Start Call. This causes the two-way radio to be pre-empted, as
End Call.
15-601104 Issue 02b (08 September 2008)
Page 32