After Exercising: How To Take Care Of Your Heart Rate Monitor - Polar Electro S120 User Manual

2. Pass the adapter wire from the Bike Mount to the chosen area
so that the wire is not hanging loosely. If necessary, wind the
wire around the front fork and brake or gear cables.
3. Place the rubber pad on the fork and the speed sensor on the
rubber pad.
4. Adjust the angle of the sensor as shown in the illustrations.
5. Pass the cable ties through the sensor and loosely adjust
the ties.
6. Install the spoke magnet so that it faces the sensor. Rotate the
magnet around the spoke before putting the metal cover on.
7. Check that the sensor does not touch the spokes. The distance
between the sensor and the magnet should be
0.12" - 0.2"/ 3 - 5 mm.
8. Tighten the cable ties securely and cut off the excess cable tie
ends.
9. Secure the adapter wire with cable ties.
Check that you can turn the handlebar normally, that cable
wires for the brakes or gearing do not catch on the sensor and
that the sensor does not disturb the use of the brakes or
gearing.
AFTER EXERCISING: HOW TO TAKE CARE
OF YOUR HEART RATE MONITOR
1. Carefully wash the transmitter with a mild soap and water
solution.
2. Rinse it with pure water.
3. Dry the transmitter carefully with a soft towel.
4. Keep the wrist receiver clean and wipe off any moisture.
5. Store the heart rate monitor in a clean dry place; dirt impairs
the conductivity and functioning of the transmitter and, sweat
and moisture can keep the electrodes wet and the transmitter
activated, shortening the battery life.
8
8