SOYO SY-6BB User Manual page 26

Quick Installation Guide
Step 17. Power On
You have now completed the hardware installation of your
motherboard successfully.
1. Turn the power on
2. When the system is performing the diagnostic checks, press the
DEL key to enter the BIOS Setup Utility.
Note: If you have failed to enter the BIOS, wait until the boot
up sequence is completed. Then push the RESET button and
press DEL again at the beginning of boot-up, during
diagnostic checks.
Repeat this operation until you get the following screen.
3. The BIOS Setup screen appears:
STANDARD CMOS SETUP
BIOS FEATURES SETUP
CHIPSET FEATURES SETUP
POWER MANAGEMENT SETUP
PNP/PCI CONFIGURATION
LOAD SETUP DEFAULTS
LOAD BIOS DEFAULTS
Esc : Quit
F10 : Save & Exit Setup
You are now ready to configure your system with the BIOS setup
program. Go to Chapter 3: BIOS SETUP
Or continue to Chapter1: INTRODUCTION and Chapter2:
HARDWARE SETUP for more information about your SY-6BB
Motherboard.
ROM PCI/ISA BIOS
CMOS SETUP UTILITY
AWARD SOFTWARE, INC.
INTEGRATED PERIPHERALS
SUPERVISOR PASSWORD
USER PASSWORD
IDE HDD AUTO DETECTION
SAVE & EXIT SETUP
EXIT WITHOUT SAVING
↑ ↓ → ←
(Shift) F2
Time, Date, Hard Disk Type...
: Select Item
: Change Color
23
SY-6BB