SOYO SY-6BB User Manual page 24

Quick Installation Guide
Warning: Follow these precautions to preserve your motherboard
from any remnant currents when connecting to ATX power supply:
Turn off the power supply and unplug the power cord
of the ATX power supply before connecting to ATX PW
connector.
This motherboard requires a power supply with at least 200 Watts
and a "power good" signal. Make sure the ATX power supply can
take at least 10mAmp load on the 5V Standby lead (5VSB) to meet
the standard ATX specification.
Note on KB Wake-Up Function Power Requirements: If you
are using the KB Wake-Up Function with 5VSB, make sure
your power supply can provide 100mAmp or higher current.
Install the ATX power according to the following pin assignment:
3.3V 3.3V
3.3V -12V
Ø Pay special care to the directionality.
Ø Make sure pin 1 is in its position.
GND 5V GND
GND PS-ON GND
ATX Power
5V GND PW-0K
GND GND
21
SY-6BB
5VSB 12V
-5V 5V 5V