Configuration (Dmx); Configuration (Standalone) - Chauvet SCORPION User Manual

Configuration
(DMX)
Starting Address
(all models)
Configuration
(Standalone)
Sound Mode (GVC
EU, RVM EU, and
RGY EU)
Scorpion™ GVC EU/RVM EU/RGY EU/BLU EU User Manual (Rev. 01d)
Setting this product to operate in DMX mode will allow you to control it with a DMX
controller.
1) Connect this product to a suitable power outlet.
2) Turn this product on.
3) Connect a DMX cable from the DMX output of the DMX controller to the DMX input
socket of this product.
When selecting a starting DMX address, you must always consider the number of DMX
channels assigned to the selected DMX mode. If you choose a starting address that is
too high, you could restrict the access to some of the channels of the DMX mode in use.
The Scorpion™ GVC EU/RVM EU/RGY EU/BLU EU fixtures use ten DMX channels,
which defines the highest configurable address to 503.
If you are not familiar with the DMX protocol, you may refer to the "DMX Primer" section
in the "Technical Information" chapter.
To select the starting address, do the following:
1) Press <MENU> repeatedly until the current starting address (001 to 503) shows
blinking on the display.
2) Use <UP> or <DOWN> to select a different starting address (001~503).
3) Press <ENT> (the new starting address will show solid on the display).
Setting this product to operate in DMX mode will allow you to control it without a DMX
controller.
1) Connect this product to a suitable power outlet.
2) Turn this product on.
Never connect a fixture that is operating in any standalone mode, whether Static,
Automatic, or Sound to a DMX string connected to a DMX controller. This is
because fixtures in standalone mode may transmit DMX signals that could
interfere with the DMX signals from the controller.
To enable the Sound mode, do the following:
1) Press <MENU> repeatedly until the active option of the Auto/Sound branch (AF1 to
rdM) appears on the display.
2) Use <UP> or <DOWN> to select a sound triggered program (So1~SoM).
3) Press <ENT> (the new sound program will show solid on the display).
4) Turn the music on.
5) Press <MENU> repeatedly until the active option of the Sound Sensitivity branch (S
0 to S 9) shows blinking on the display.
6) Use <UP> or <DOWN> to select the sensitivity level (S 0~S 9).
7) Press <ENT> (the new sound sensitivity will show solid on the display).
The fixture will only respond to the low frequencies of the music (bass and
drums).
Page 17 of 28