Configuration (Dmx); Starting Address; Dmx Personalities - Chauvet Intimidator Spot 355 IRC User Manual

Configuration
(DMX)

Starting Address

DMX
Personalities
Intimidator Spot 355 IRC User Manual Rev. 1
Set the product in DMX mode to control with a DMX controller.
1. Connect the product to a suitable power outlet.
2. Connect a DMX cable from the DMX output of the DMX controller to the DMX input
socket on the product.
When selecting a starting DMX address, always consider the number of DMX channels
the selected DMX mode uses. If you choose a starting address that is too high, you could
restrict the access to some of the product's channels.
The Intimidator Spot 355 IRC uses up to 14 DMX channels in its 14-channel DMX mode,
which defines the highest configurable address to 499.
If you are not familiar with the DMX protocol, download the DMX Primer from
www.chauvetlighting.com.
To select the starting address, do the following:
1. Press <MENU>.
2. Use <UP> or <DOWN> to choose Address.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select the starting address.
5. Press <ENTER>.
The Intimidator Spot 355 IRC has two DMX personalities, a 14-channel personality and
an 8-channel personality.
To choose which DMX personality to use, follow the steps below:
1. Press <MENU>.
2. Use <UP> or <DOWN> to choose Run Mode.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select DMX.
5. Press <ENTER>.
6. Use <UP> or <DOWN> until either 14CH (to choose the 14-channel personality) or
08CH (to choose the 8-channel personality) shows on the display.
7. Press <ENTER>.
Page 11 of 25