Led Frequency; Fan Mode; Back Light; Run Time - Chauvet Ovation E-260WW User Manual

LED Frequency

Fan Mode

Back Light

Run Time

Software
Information

RDM

Configuration
(DMX)
DMX
Personalities

DMX Control

Ovation E-260WW User Manual Rev. 1
This option changes the Pulse Width Modulation (PWM) frequency of the LEDs on the
Ovation E-260WW.
1. Go to the LED Frequency main level.
2. Choose an output frequency. (600Hz, 1200Hz, 2000Hz, 4000Hz, or 25KHz)
This option toggles the fan speed from being always on and auto control based on the product's
temperature.
1. Go to the Fan Mode main level.
2. Select a fan mode (Auto, or On).
This setting allows you to set the amount of time the backlight on the Ovation E-260WW's
display stays on after the last button is pressed on the control panel.
1. Go to the BackLite main level.
2. Select On (remains on), 10S (10 seconds), 20S (20 seconds), or 30S (seconds).
This option show how many total hours the product has been on.
1. Go to the Information main level.
2. Select Fixture Hours and the amount of hours will show on the screen.
This option shows what version of software the Ovation E-260WW is running.
1. Go to the Information main level.
2. Select Version and the version number will show on the screen.
This option shows the product's UID #. The UID # is used when using the RDM functionality of
this product.
1. Go to the Information main level.
2. Select UID: and the number will show on the screen.
Use DMX configurations to operate the product with a DMX controller.
This setting allows you to choose a particular DMX personality.
1. Go to the DMX Channel main level.
2. Select the desired personality (1Ch, 2Ch, 3Ch, or 6Ch).
·
See the DMX Values
personality.
·
Make sure that the starting addresses on the various products do not overlap due to
the new personality setting.
In this mode, each product will respond to a unique starting address from the DMX controller. All
products with the same starting address will respond in unison.
1. Select a DMX personality as shown in
2. Set the running mode:
a. Go to the Master/Slave main level.
b. Select the Master programming level.
3. Set the starting address:
a. Go to DMX Address main level.
b. Select the starting address (001–512).
The highest recommended starting address for each DMX mode is as follows:
DMX Personality
1Ch
6Ch
section for the highest starting address you can select for each
DMX Personalities.
DMX Address
508
506
DMX Personality
2Ch
3Ch
Operation
DMX Address
503
500
-13-