Setup; Ac Power - Chauvet SCORPION User Manual

3. S
ETUP

AC Power

Fuse
Replacement
Interlock
Connector
Scorpion™ GVC EU/RVM EU/RGY EU/BLU EU User Manual (Rev. 01d)
This product has an auto-ranging power supply and it can work with an input voltage
range of 100~240 VAC, 50/60 Hz.
To determine the power requirements for a particular fixture, see the label affixed to the
back plate of the fixture or refer to the fixture's specifications chart. A fixture's listed
current rating indicates its average current draw under normal conditions.
Always connect this product to a protected circuit (circuit breaker or fuse),
making sure that it has an appropriate electrical ground to avoid the risk of
electrocution or fire.
Never connect this product to a rheostat (variable resistor) or dimmer circuit, even
if the rheostat or dimmer channel serves only as a 0 to 100% switch.
This fixture uses an F 1 A, 250 V fuse. Follow the instructions below to change it in case
it blows.
Disconnect this product from the power outlet before replacing the fuse.
1) Wedge the tip of a flat head screwdriver into the slot of the fuse holder and pry it out
of its housing.
2) Remove the blown fuse from its holder and replace it with a fuse of the exact same
type and rating.
3) Insert the fuse holder back in its place, and reconnect power.
Always replace a blown fuse with a good fuse of the same type and rating.
This product has a jack for a remote interlock switch that would shut off the laser output
in case of emergency. You may use the provided remote interlock connector to build
your own interlock switch.
The fuse is located inside
this compartment.
Page 11 of 28