How To Install The Hob - CDA HVC93 Manual For Installation, Use And Maintenance

How to Install the Hob

How to install the hob:
Overall dimensions of the hob: HVC93 width 900mm depth 350mm
Worktop cut-out dimensions:
1. Make the required hole in the worktop. Before doing this, you must check the instructions supplied with any cooker
hood to ensure that you will have the required clearance. The cut-out (Fig.9) shows a 60mm gap from the wall to the
cut-out edge. The distance from the hob, when fitted, to the back wall is 50mm. If a splashback/worktop upstand is to
be fitted, take this into account when cutting the hole. The minimum distance that the hob should be positioned away
from the rear wall or splashback is 50mm.
2. Position the hob seal, as shown in (Fig. 1 1), ensuring that the ends meet without overlapping. Do not use silicone type
sealant.
3. Secure the hob to the worktop using the fixing brackets and screws supplied, as shown in (Fig. 1 2). Remove any excess
sealant after tightening the brackets. Do not over-tighten the fixing brackets.
185mm
150mm
190mm
Fig.9
Fig. 1 1
13
HVC93 width 880mm depth 335mm
>60mm
65mm
335mm
470mm
880mm
550mm
185mm
150mm
190mm
Fig. 1 0
Fig. 1 2
3cm
4cm