Table of Contents
Advertisement
How to use the hob
The Timer/ Minute Minder
The timer allows you to preset the length of time any of the zones will be on, between a minimum of one minute and
a maximum of 99 minutes. The timer can be used on each zone separately and can also be used as a minute minder, to
countdown the time without using any of the zones.
To set the timer
Switch on the zone and set the power level.
Whilst the dot is showing on the zone display, touch
on to show which zone timer is being set.
To set the time from zero, touch and hold
To go straight to 30 minutes, touch
Then touch either
or
to adjust the time further.
To change the timer once set
Touch
for the required zone.
Touch
. The remaining time for the active zone will show on the timer display.
Touch
or
to adjust the time.
To cancel the timer once set
Touch
to activate the timer, then touch
Please note:
If you cancel the timer, the zone will continue at the set power level until it is switched off as described above.
At the end of the set time:
The zone will switch off.
The timer display will flash 00 and the timer indicator will flash, then will switch off if no other timers have been set
The zone display will show H to indicate the residual heat.
The hob will beep for approximately 2 minutes. To switch off the beep, touch any key.
If no other zones are in use, then the hob will switch off automatically.
To set the minute minder
Touch
. The timer display will show 00 and the minute minder indicator will switch on.
To set the time from zero, touch and hold
To go straight to 30 minutes, touch
Then touch either
or
to adjust the time further.
If the minute minder is set, the hob will switch off after ten seconds, and the minute minder will continue to run.
Please note:
The timer will start as soon as the time has been set.
If more than one zone timer is set, the timer display will show the countdown for the last timer set.
If more than one timer is set, touch
timer is being displayed.
. The timer display will show 00 and the timer zone indicator will switch
until the required cooking time shows on the display.
.
to reduce the time required until the zone display shows 0.
until the required time shows on the display.
.
repeatedly to cycle through each of the timers set. The timer indicators will show which
6
Advertisement
Table of Contents
