Table of Contents
Advertisement
1. Connecting the Machine
1.
A ferrite core for the Ethernet interface cable is supplied with this machine. Make a loop in
the cable about 3 cm (1.2 inch) (1) from the machine end of the cable. Attach the ferrite core.
1
2.
Make sure the main power switch of the machine is off.
3.
Connect the Ethernet interface cable to the 10BASE-T/100BASE-TX port.
4.
Connect the other end of the Ethernet interface cable to a network connection device such
as a hub.
5.
Turn on the main power switch of the machine.
1. Indicator (yellow)
When 100BASE-TX is operating, the LED is lit yellow. When 10BASE-T is operating, it is turned
off.
2. Indicator (green)
When 10BASE-T is operating, the LED is lit green. When 100BASE-TX is operating it is turned
off.
16
BBM011S
BAW013S
BAX003S
Advertisement
Table of Contents
