Table of Contents
Advertisement
3. Copier/Document Server Features
Input/Output
This section describes the user tools in the Input/Output menu under Copier / Document Server Features.
Default settings are shown in bold type.
Switch to Batch
You can select to have Batch mode or SADF mode displayed when you press [Special Original].
The default setting is Batch.
3
SADF Auto Reset
In SADF mode, an original must be set within a specified time after the previous original has been fed.
The default setting is 5 second(s).
You can adjust this time from 3 to 99 seconds in increments of 1 second.
Rotate Sort: Auto Paper Continue
Specify to continue copying when paper of the required orientation has run out during rotate sort.
The default setting is Off.
• On
Copying continues using copy paper of a different orientation. The copy job will finish even if
you have left the machine.
• Off
When paper of the required orientation runs out, the machine stops copying and prompts you
to supply copy paper. After you have loaded paper, the machine will continue copying.
Copy Eject Face Method in Glass Mode
You can specify the way in which copies are delivered when copying an original placed on the
exposure glass.
The default setting is Face Up.
Copy Eject Face Method in Bypass Mode
You can specify the way in which copies are delivered when copying in bypass mode.
The default setting is Face Up.
Memory Full Auto Scan Restart
When memory becomes full while scanning originals, the machine can make copies of scanned
originals first, and then automatically proceed scanning remaining originals.
The default setting is Off.
• On
You can leave the machine unattended to make copies, but sorted pages will not be sequential.
• Off
114
Advertisement
Table of Contents
