Table of Contents
Advertisement
How to Install the Hob
How to install the hob:
Overall dimensions of the hob:
Worktop cut-out dimensions:
1. Make the required hole in the worktop. Before doing this, you must check the instructions supplied with any cooker hood
to ensure that you will have the required clearance. The cut-out (Fig.4) shows a 60mm gap from the wall to the cut-out
edge. The distance from the hob, when fitted, to the back wall is 50mm. If a splashback/worktop upstand is to be fitted,
take this into account when cutting the hole. The minimum distance that the hob should be positioned away from the rear
wall or splashback is 50mm.
2. Position the hob seal, as shown in Fig.6, ensuring that the ends meet without overlapping. Do not use silicone type sealant.
3. Secure the hob to the worktop using the fixing brackets and screws supplied, as shown in Fig.7. Remove any excess sealant
after tightening the brackets. Do not over-tighten the fixing brackets.
185mm
150mm
190 mm
Fig.4
Fig.6
Width: 585mm Depth: 500mm
Width: 550mm Depth: 470mm
60 mm
65mm
470 mm
470mm
550 mm
550mm
185mm
150mm
190 mm
Fig.5
Fig.7
3cm
4cm
8
Advertisement
Table of Contents
