Care And Maintenance - CDA HCE550 Manual For Installation, Use And Maintenance

Care and Maintenance

Always disconnect the appliance from the power supply before undertaking any cleaning or maintenance.
You should use a non-abrasive cleaner to clean the hob top. Any abrasive cleaner (including Cif) will scratch the surface and
could erase the control panel markings.
Stainless steel can be effectively cleaned by simply using a dilute solution of water and washing up liquid and drying to a
shine with a clean cloth.
With use the stainless steel surface may discolour; this is normal and does not constitute a fault with this appliance.
Proprietary stainless steel cleaners are available.
Please contact CDA Customer Care if you have difficulty obtaining a suitable cleaning product (see details below).
Hotplate Care:
The finish of the cast iron hotplates are designed to be durable in use. The following tips should be observed to get the best
from your hob:
1. Do not use decorative covers; these can cause damage the surface and lead to rust.
2. Use a special hotplate surface cleaner to protect and restore the surface of the hotplates.
3. Do not use soap and water on the hotplates. Wipe up spills and splashes immediately.
4. Never operate the hob without a pan, unless it is for a few seconds (as below).
5. Deposits of fat can be burned off by turning the hotplate on for a few seconds. The fat will brush off when the
appliance has cooled down.
Important:
• Steam cleaners must not be used when cleaning this appliance.
Mains electrical voltage:
Total rated electrical consumption:
If your Hob is not working:
1. Check that the control knobs are switched on.
2. Check that the mains supply has not been switched off.
3. Check that the fuse in the spur has not blown.
Contact CDA Customer Care
A : Customer Care Department, The CDA Group Ltd, Harby Road, Langar, Nottinghamshire, NG13 9HY
T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.eu
5
230 – 240Vac
6.0 kW