Stop The Engine; Release Lever - Jonsered FR 2113 MA 4X4 Operator's Manual

• The mowing results are best with a high engine speed
(fast rotating blades) and low driving speed (slow moving
machine). If the grass is not too high and thick, the driving
speed can be increased without noticeably depreciating
the mowing result.
• The best lawns are achieved if the grass is cut often.
Mowing becomes more uniform and the grass cuttings
become more evenly distributed over the surface. The
total time consumption is not greater since it is possible to
select a higher driving speed without inferior mowing
results.
• Avoid mowing a wet lawn. The mowing results are inferior
since the wheels sink down into the soft lawn.
• Hose down the cutting unit with water underneath each
time it is used. The cutting unit should then be put in the
service position.
• When the Mulching function is used, it is very important
that the mowing interval is not too long.
WARNING! Clear the lawn from stones and
!
other objects which can be thrown out by
the blades.
WARNING! Do not use the machine on
!
ground that slopes more than 10° ° ° ° . . . . Mow
slopes upwards and downwards, never
across. Avoid sudden changes in direction.

Stop the engine

Preferably allow the engine to idle for a minute to obtain
normal working temperature before stopping it if it has been
working hard.
1 Lift up the cutting unit by pulling the lever backwards to its
locked position.
Driving
1 Pull back the throttle and turn the ignition key to the
"STOP" position.
2 When the Rider is at a standstill, press down the parking
brake and push in the locking button.

Release lever

The release control must be pulled out in order for the
machine to be moved when the engine is shutoff.
Pull the controls to the end positions, do not use an
intermediate position.
Clutch control, rear axle
• Control drawn out, drive system disengaged.
• Control depressed, drive system engaged.
Clutch control, front axle
The control is positioned on the inside of the left front wheel.
• Rear control (pulled out), drive system disengaged.
• Front control (pushed in), drive system engaged.
STOP START
– 17
English